1st Interlace with macrame (A)
We prepare the hair by texturing roots, then we mark the middle and ends with a 38mm diameter tweezers, leaving the ends slightly less marked, we brush the hair, apply a little shine with a spray and the hair is ready to start working.
Next, we separate a section, taking the front and the sides, we reserve it, and then we take a section at the crown with which we make a ponytail.
Then, we take two strands, leaving the macrame cords in the center and make a ponytail. With a strand, we cover the hair tie.
We continue with this section and at about 5 or 6 cm we place another hair tie and make a turned bubble. We continue, doing the same step on the right side. We take the central section and 5 or 6 cm from the previous hair tie, we make a new bubble. We repeat the same step on the left side.
We continue taking a section of hair between the strings and repeat the previous steps, creating small round bubbles, but this time without intertwining the strings. We repeat the previous step on the right side.
2nd Bubble fishtail braid (B)
We start by preparing the hair by texturing the roots, then mark the middle and ends with a 38mm diameter tweezers, leaving the ends slightly less marked. We brush the hair, apply a little shine with a spray and the hair is ready to start working.
Next, we separate a section, taking the front and the sides, we reserve it and then we take a section at the crown with which we make a ponytail. We introduce the ponytail through the center of the section and remove a little fluffiness.
Next, from the previous section, we take the guide wick and make a fishtail braid of about 5 or 6 cm, and secure it with a hair tie.
We open the braid giving fluffiness and providing textures. Next, we take two sections from the sides and attach it to the middle section. We continue with our central strand and make a 5 or 6 cm fishtail braid, open it and remove the fluffiness, then secure with another hair tie.
We continue, taking the remaining hair and joining it to our central updo. Then, we separate our strand into two equal sections, in the upper one we make a fishtail braid and secure it with a hair tie. We join the remaining section with another hair tie to the previous one.
We keep on doing the previous steps (joining the central updo and separating the strand into two equal sections to then make a fishtail braid) throughout the length of the hair. We open it creating that fluffiness and destructuring it, to achieve a more natural effect.
3rd Lateral pull through braid ( C)
We start by preparing the hair by texturing roots. Afterwards, we mark means and ends with a 38mm diameter tweezers, leaving the points slightly less marked. We brush the hair, apply a little shine with a spray and the hair is ready to start working.
Next, we separate the front and the sides, take the crown section and move it to the side and make a ponytail with the hair from this section.
We take the next section, of 3cm approximately, and we make a ponytail parallel to the previous one. Next, we make with the next section the same as in the previous step, to get a third ponytail.
Afterwards, we open the first queue in two and raise the second, passing through the center, the two ends of the first queue are joined to the third. We take a new section of the remaining hair and make a new ponytail, parallel to the previous ones.
Then, with the following ponytails, we open the first ponytail in two and go up the second one, passing through the center, we join the two ends of the first ponytail to the third. And we repeat the same steps until we finish with all hair.
Finally, we open each link creating fluffiness and an unstructured feel, according to pure Medialdea Method.
4th Combo braid (D)
We start by preparing the hair by texturing the roots. Afterwards, we mark the middle and ends with a 38mm diameter tweezers, leaving the ends slightly less marked, brush the hair, apply a little shine with a spray and the hair is ready to start working.
Next, we separate the front and the sides, take a section of the crown, make a slight twist and fasten with a bun hairpin.
Then, we take the strand from this section, add a little hair from below and with this strand we make a caterpillar braid, of 6 or 7 cm.
We fix our braid with a hair tie that we cover it with a hair strand.
We continue, taking the next section that goes from the height of the eyebrow to the other eyebrow and we make a central ponytail that in turn we introduce through the center of the section.
Later, we join our caterpillar braid to this ponytail with a hair tie that we later cover with hair. Once done, we make a bubble and deconstruct it a bit. We take the rest of the hair, we attach it to our center section and cover the hair tie. Then with the entire ponytail created, we make a pull through braid up to the middle of the hair’s length and fasten with a hairpin.
We open our braid creating fluffiness, following the Medialdea Method. With the excess of hair we continue making the pull through braid until finishing with all hair. We give it fluffiness and volume, as in the previous section.
To finish, we secure the end of our braid with a transparent hair tie.
Hair: Juanmy Medialdea
Hair Instagram: @juanmy_medialdea
Hair Assistant: Sergio Castillo @sergiocastillo_makeup
Photography: Jose Santo Palomo @santopalomo
Make up: Sergio Castillo
Styling: Juanmy Medialdea
Models: Lucía y Andrea
Thanks for your like and your comment !
